[928uk] New transmission mounts
Adrian Langford
adrian.langford at qualitative.co.uk
Sat Aug 12 09:14:14 UTC 2017
Hi Graham
People more competent than me have found it easy and managed it in 30 minutes per side! For me it was a very awkward job, but I could do it very fast now having figured out access tricks.
That is correct part number for mount.
Removing lower bolts is easy. Clear access left side. On right side I created a little more room by unbolting Handbrake cable Bracket from crossmember (one 10mm head bolt), removing the bracket that screws into base of trans fluid reservoir, and using a 3/8 19mm socket which is that bit slimmer.
You need to jack up trans slightly after removing lower bolts, to take tension off upper bolts into trans case, and create room for new uncompressed mounts.
On the left side access is pretty good from the front, but there's no room for head of ratchet or breaker bar. A spanner works here so you can slip over upper mount and bash it with hammer to break upper bolt free (in my case I had a good through ratchet to use with 19mm socket).
On the right side access was trickier, but you can get right through to upper bolt from side of car with long 3/8" extension (you need an 18" one). I didn't have one handy so my only option was to get to upper bolt from below and rear, and to make enough room I had to disconnect axle at diff and then hang it up out of way with wire. With that out of way there's room for short breaker bar - I broke torque pushing end of bar towards front of car with my foot! Disconnecting axle requires removing Allen bolts with good socket two at a time (the CV joint is hanging so allows only partial access), scuttling from under car each time to take off Handbrake, rotate next pair of bolts into position, and reapply Handbrake.
Inserting new mounts and upper bolts is more from feel than sight but make sure trans is high enough to create room. You can keep upper and lower bolts just nice and loose before lowering trans and doing final torque to spec. I had car fairly high on my QuickJack ramps, but could adjust trans height with trolley jack and big slab of wood.
Having decent inspection lights is a must. It's gloomy and shadowy up there!
Just shout with any other questions!
All the best
Adrian
iPhone therefore I am
> On 12 Aug 2017, at 09:32, Graham Few <postmaster at grahamfew.plus.com> wrote:
>
> Hi Adrian
> A job I will be adding to my preventive maintenance list.
> I have looked at the PET for my 87 S4 auto, assuming the mount is the same as for your 91 auto, can you confirm the part number is 928.375.045.16.
> Is it fairly easy to replace them?
> Regards
> Graham
>> On 21 Jul 2017, at 14:52, Adrian Langford via 928uk <928uk at lists.928.org.uk> wrote:
>>
>> Just back from test drive after installing the new mounts on my MY91 Auto.
>>
>> The old ones (just under 80,000 miles on them) were only a little collapsed, and the transmission still had some clearance above crossmember, so I wasn't expecting much difference. I did the job more as preventive maintenance.
>>
>> But there's a definitely more smoothness to the shifts especially at wide throttle openings - they feel so silky! Old rubber may explain this. The new mounts dated 2016 so Porsche still making 'em.
>>
>> Adrian
>>
>>
>>
>> iPhone therefore I am
>> _______________________________________________
>> 928uk mailing list
>> 928uk at lists.928.org.uk
>> https://lists.928.org.uk/mailman/listinfo/928uk
>
More information about the 928uk
mailing list