[928uk] Late 1991 S4 auto analogue clock wiring question.
Paul R Smith
smiffypr at gmail.com
Sun Dec 15 21:26:24 UTC 2024
One red wire going onto the first pin. This is pin 4, 30 bus, permanent positive
Two black and blue wires going into the second pin. This is pin 3 the positive feed to the bulb, would normally come via the rheostat.
One black wire to the third pin. This is pin 2, 15 bus ignition on feed for the clock (+ve)
One brown wire to the fourth pin. This is pin 1, GROUND (-ve)
You can wire 4, 3 and 2 to +ve but you should really do it via a low
amps fuse, and 1 (brown) to negative.
I suspect that (but it's just a guess) that you need pin 2 powered to
adjust the clock, but pin 4 Red is probably making the clock work. Note
that I have used the wiring diagram pin numbers, not yours.
Smiffy
On 15/12/2024 20:04, Simon Watson via 928uk wrote:
Hi all. Could anyone kindly tell me please which wires do what on clock off S4 first UK registered October 1991. I have a nice S4 analogue clock on the bench and I want to test it. But I don’t want to get it wrong and wreck it!
There is a black four pin plug going into the back of the clock.
One red wire going onto the first pin.
Two black and blue wires going into the second pin.
One black wire to the third pin.
One brown wire to the fourth pin.
It also has a light bulb in the back of the clock, the bulb holder is twisted into the internal circuitry.
Will it be safe (once I know which wires to connect to where) to connect them direct to a car battery on the bench?
Many thanks,
Simon
Sent from my iPhone
More information about the 928uk
mailing list