[928uk] VSS

Paul R Smith smiffypr at gmail.com
Mon Dec 16 16:29:45 UTC 2024


The signal wire (with the sender disconnected) will be (as you expect) a 
voltage via a high resistance, and when the sensor (reed switch) is 
operated by a magnet in the diff, it will short this to ground. I think 
there are ten magnets, so 10 "pulses" per revolution. I would have 
expected the signal to be more than 5v, but I've never measured it. You 
could check the signal wire voltage at the dash to compare.

Smiffy

On 16/12/2024 15:57, emlynmiles--- via 928uk wrote:

Thanks Paul
Mine is a 1989 S4 with the digital dash, I have a spare so I am able to swap things around, cannot find anything other than 5v seems low, sender seems to be ok it’s the magnetic type.

Cheers
Emlyn
Sent from my iPhone

On 16 Dec 2024, at 15:46, Paul<ukkid35 at gmail.com>  wrote:


Worth bearing in mind that the sensor is actually a reed switch

Not quite sure what the frequency is per revolution though

My Speedo/Odo stopped working about three years ago and I've still not been able to find the issue

Rennlist suggests that dry solder joints on the dash circuit foil is the most likely cause

Paul
87 S4 Manual

On Mon, 16 Dec 2024 at 15:27, emlynmiles--- via 928uk <928uk at lists.928.org.uk<mailto:928uk at lists.928.org.uk>> wrote:
Hi everyone

Does anybody know what the input voltage should be at the speed sensor at the back axle, getting 5v at the moment.

Merry Christmas all
Emlyn
Sent from my iPhone




More information about the 928uk mailing list